5 Stud wheel spacers used for Mercedes Gelandewagen
You can use these wheel spacers to push out the wheel a bit. Some people do it for the looks and others use it because they fit new rims and the new rims catches the calipers.
The wheels spacer bolts onto the vehicle on the existing studs with the nuts supplied. Your wheel then bolts onto the wheel spacer using the studs on the wheel spacer and your original nuts.
Make sure the surface on the vehicle hub is clean and free from any debris before fitment. The same applies to the back of the wheel spacer which should be clean. Tighten all nuts by hand first, then torque in cross over sequence to 30 Nm. Then Torque to 100Nm. When you have them fitted at a tyre fitment centre, keep an eye on the procedures because they normally tighten it with impact wrench. DO NOT allow them to use an impact wrench and make sure they tighten them in cross over sequence. Check the wheel spacer nuts after the first 500 km to make sure they are tight. Thereafter check every 5000km.
This extra stud fits the 6 stud wheel spacer used for Hilux, Ford, Mazda, Mitsibushi and others.
Stud - M12x1.5mm - high tensile 12.9 grade
Nuts - 40CrMo high tensile steel
These extra studs will fit the 5 stud Land Cruiser wheel spacer - M14 x 1.5
Stud - M14x1.5mm - high tensile 12.9 grade
Nuts - 40CrMo high tensile steel
Please note:It does not fit on Hilux Revo Models(2016-onwards)
The Revo's standard studs are too short
6 Stud Wheel Spacer for Hilux, Triton, Ford, Isuzu. 6 stud
PCD139.7mm and centre bore is 108mm 30mm thick